A starter is installed in a vehicle. In the starter, a crank shaft is driven by a motor which rotates a pinion gear in a state where a ring gear connected to the crank shaft is in engagement with the pinion gear. Thus, an engine is started. The starter sets a start-up period depending on the type of the start-up trigger that generates a start-up request for the engine, and sets a current supplied to the motor on the basis of the set start-up period. Thus, at least either of a rotation speed and an output torque of the motor is controlled. This control is implemented by a control circuit.

A method of controlling power to a vehicle accessory gradually shuts down power to the vehicle accessory and gradually restores power to the vehicle accessory. After a request for an auto-shutdown of an internal combustion engine of a vehicle is detected, power to the vehicle accessory is reduced on a predetermined schedule responsive to such detection. The occurrence of a restart of the internal combustion engine of a vehicle is determined, and power supplied to the vehicle accessory is increased on a predetermined schedule responsive to the restart.

In some embodiments, a vehicle includes a temperature monitoring controller. The temperature monitoring controller is a processor, control module, or other suitable hardware that is configured to receive temperature sensor values from an engine control module (ECM) when an ignition bus is in a powered on state, and to decide when the engine should be automatically started in order to maintain a temperature above a low temperature threshold. The temperature monitoring controller periodically causes an ignition bus of the vehicle to be placed in the powered on state when the engine is shut down in order to collect temperature sensor values. The temperature monitoring controller determines whether to automatically start the engine, and if not, determines how long to wait before collecting temperature sensor values again based on a rate of change of the temperature sensor values.

A controller for a vehicle includes failure diagnosis circuitry and drive control circuitry. The failure diagnosis circuitry is configured to perform a failure diagnosis of an internal combustion engine system while an internal combustion engine is in operation. The drive control circuitry is configured to operate the internal combustion engine in a charge depleting mode operation in which an electric motor mainly moves the vehicle while the internal combustion engine is not run only for charging a battery. The drive control circuitry is configured to run the internal combustion engine if a predetermined condition is satisfied in the charge depleting mode operation. The drive control circuitry is configured to continue running the internal combustion engine in order to perform the failure diagnosis even if the predetermined condition is unsatisfied while the internal combustion engine is run in the charge depleting mode operation.

A vehicle includes a rear visibility component having a heating element. The vehicle further includes an engine and at least one controller programmed to auto-start and auto-stop the engine. The at least one controller is programmed to inhibit the auto-stop of the engine in response to receiving an auto-stop request while the engine is on and the heating element has been operating less than a predetermined time. In some configurations, the at least one controller is programmed to auto-start the engine and operate the heating element at a full power level in response to expiration of a time period that began with an auto-stop of the engine that occurred after the engine auto-stop was inhibited.